Ooni Koda 2 Dimensions: Exact Size, Weight and Space Needed
8 min read · by Arjun Mehta · Last updated: November 6, 2026
Ooni Koda 2 dimensions are 545 x 472 x 333 mm (21.5 x 18.6 x 13.1 in) unboxed. The shipping box is larger, so check the boxed size too if the oven has to pass through a door or up stairs.
The ooni koda 2 dimensions below are for the standard 14-inch Koda 2, not the larger Koda 2 Pro. Confirm the model name on the box before you measure your space.
Ooni Koda 2 Dimensions: Unboxed and Boxed Sizes
The Ooni Koda 2 measures 545 x 472 x 333 mm unboxed and 682 x 557 x 339 mm in its box, according to Ooni’s product listing.

The unboxed size is the one that matters for placement on a table, countertop or patio shelf. The boxed size matters for delivery and storage. Ooni’s US listing prints one side as 28.4 in, which does not match its 472 mm figure, so measure your space in millimetres to be safe.
| Measure | Unboxed | Boxed |
|---|---|---|
| Metric (W x D x H) | 545 x 472 x 333 mm | 682 x 557 x 339 mm |
| Imperial | 21.5 x 18.6 x 13.1 in | 26.85 x 21.93 x 13.51 in |
Use the unboxed numbers when you plan where the oven will sit. Add room around the ooni koda 2 dimensions for the clearance rules covered further down, because the footprint alone does not show how much space you need.
Ooni Koda 2 dimensions are easiest to plan with a tape measure and a rough sketch of your space. Mark the 545 mm width and 472 mm depth on the floor or table, then check that the 333 mm height clears any shelf, cover or overhang above it. Ooni lists the same size as 54.5 x 47.2 x 33.3 cm in centimeters and 21.5 x 18.6 x 13.1 inches for those who measure in inches. Write down the boxed size as well if you plan to carry the oven through a narrow hallway.
How Much Does the Ooni Koda 2 Weigh?
The Ooni Koda 2 weighs 16 kg (35.27 lb) unboxed and 21.3 kg (46.96 lb) in its box, according to the same Ooni listing.
That weight is manageable for one adult over a short distance, but the box adds about 5 kg. Ooni’s manual also says not to lift the oven while the pizza stone is in place, so take the stone out first. Check the boxed ooni koda 2 dimensions against doorways and stair widths before delivery.
- Unboxed: 16 kg (35.27 lb)
- Boxed: 21.3 kg (46.96 lb)
- Lifting: never with the pizza stone in place, per the manual
The weight matters most if you store the oven on a balcony shelf or move it between a garage and a patio. Weight and the ooni koda 2 dimensions answer different questions: weight tells you how hard the oven is to move, and dimensions tell you where it fits. If you are weighing a smaller oven, our guide to Ooni Fyra 12 dimensions covers its size, weight and the space to plan.
Ooni’s manual also says to allow the oven to cool completely before you cover or move it, and never to move it while it is in use. Plan any move for after cooking, and keep the stone out during the lift. If you carry the oven to a storage spot, measure that spot against the Ooni Koda 2 dimensions first, because a cabinet that is a few centimeters too shallow is a common surprise.
Ooni Koda 2 Size and Pizza Capacity
The Ooni Koda 2 cooks pizzas up to 14 inches in diameter, as stated on Ooni’s Canada product guide.

Pizza size is the limit that matters most when you compare the oven with your plans. A pizza larger than 14 inches will not fit the stone, whatever the outside footprint looks like. Ooni Canada’s Koda 2 getting-started page confirms the 14-inch maximum.
The stone is removable. The manual says to slide it in and out with both hands, and to cook only dry, bread-based dishes directly on it.
When you compare the ooni koda 2 dimensions with a recipe, the stone is the real limit, not the outer case. A dough larger than 14 inches will need to be shaped smaller before it goes in. For the heat the stone should reach, read pizza oven temperature guidance.
Propane and Gas Cylinder Size for the Koda 2
The Koda 2 is optimized for propane and needs a cylinder with a fuel capacity under 20 lb (9.1 kg).
The manual sets limits on the cylinder you can connect. Check your bottle against this list before you buy, as described in Ooni’s Koda 2 assembly manual.
- Fuel capacity: under 20 lb (9.1 kg)
- Maximum cylinder diameter: 22.8 in (580 mm)
- Maximum cylinder height: 22.8 in (580 mm)
- Fill no more than 80 percent full
Use only the pressure regulator and hose supplied with the oven, and never store a spare cylinder under or near it. For an idea of the heat this fuel delivers, see propane pizza oven temperatures.
Inspect the hose before each use, and replace it if it shows abrasion, cuts or leaks, as the manual requires. Put the dust cap on the cylinder valve whenever the cylinder is not in use. Plan the bottle’s position around the ooni koda 2 dimensions, so the hose can reach the oven without strain.
Space and Clearance You Need Around the Oven
The manual says to keep the Koda 2 at least 40 in (1 m) from any structure or combustible material.
Clearance is a minimum, not a target, so a bigger gap gives you more margin. Mark out the Ooni Koda 2 dimensions on your table or patio first, then add the clearance around that outline.
- Keep 40 in (1 m) from any structure or combustible material
- Keep 25 ft (7.5 m) from any flammable liquid
- Set the pizza stone about 43 in (1.1 m) above the ground
- Use it outdoors only, never in a garage, boat or RV
- Point the oven mouth away from the wind
The 43 in height is a recommendation for the stone, so check your table or stand height before you set the oven on it.
The manual also limits where the oven can run. It counts as outdoors only if its shelter has an overhead cover and no more than two sidewalls, and sliding doors, garage doors, windows and screened openings do not count as permanent openings. A garage or screened room does not meet that test. If you are weighing a permanent spot, our guide on whether you can leave a pizza oven outside covers weather and storage.
Koda 2 vs Koda 2 Pro: Which Size Are You Looking At?
The Koda 2 and Koda 2 Pro are separate Ooni models, so the ooni koda 2 dimensions in this article apply only to the standard 14-inch Koda 2.
The names are close, which makes it easy to measure the wrong model. The manual lists the codes UU-P2D100, UU-P2D200 and UU-P33500, so match one of them against the code on your carton before you trust any size.
If the box or product page says Koda 2 Pro, stop and use that model’s measurements, which are in our guide to the Ooni Koda 2 Pro dimensions. The ooni koda 2 dimensions in this article would be the wrong numbers for a Pro. If you are also weighing an electric model, see the Ooni Volt 2 dimensions.
Frequently Asked Questions
Will the Ooni Koda 2 fit on a standard table?
Start by comparing the ooni koda 2 dimensions, specifically the unboxed footprint of 545 x 472 mm, with your table. Then check the 40 in (1 m) clearance from any structure, and confirm the surface can bear the oven’s weight, as the manual advises.
How much does the Ooni Koda 2 weigh when boxed?
The boxed ooni koda 2 dimensions are 682 x 557 x 339 mm. The boxed Ooni Koda 2 weighs 21.3 kg (46.96 lb), compared with 16 kg (35.27 lb) unboxed. Take the pizza stone out before lifting the oven, as the manual advises.
What is the largest pizza the Ooni Koda 2 can cook?
The Ooni Koda 2 cooks pizzas up to 14 inches in diameter. A larger pizza will not fit the stone, so use 14 inches as your limit when you plan dough sizes.
Is the Ooni Koda 2 safe to use indoors?
No. The manual says the Koda 2 is for outdoor use only and must not be used inside a building, garage, boat or recreational vehicle. It is not intended as a heater.
What height should the Ooni Koda 2 sit at?
Ooni recommends positioning the oven so the pizza stone sits about 43 in (1.1 m) from the ground. Check your table or stand height first, and keep the oven mouth facing away from the wind.
Does the Ooni Koda 2 run on natural gas?
The Koda 2 is optimized for propane, which the manual calls LP gas. Connect only the gases listed on the rating plate, and use a cylinder that meets the size limits in the propane section.
Measure the ooni koda 2 dimensions, add the 40 in clearance, and confirm the model name on the box before you order. If you are comparing the Koda 2 Pro, use that model’s own measurements rather than these.