Gozney Dome S1 Stand: Clearance, Floor Load and Setup Rules
8 min read · by Hannah Cole · Last updated: November 17, 2026
The gozney dome s1 stand you choose must hold the oven at the manual’s clearances, on a level floor rated for 60 kg. The Dome S1 technical manual sets these rules for outdoor use, and they apply to any table or base you put the oven on.
The manual does not list stand dimensions or weight, so this guide sticks to its figures. Measure the footprint you plan to use before you order any gozney dome s1 stand or table. If your oven is a different Dome generation, see our guide to a table for the Gozney Dome.
Gas connection, leak testing and placement must follow the manual and local rules. This guide explains what the manual asks for and does not replace it.
What the Dome S1 Manual Requires Under a Stand
The manual requires a level, stable surface that holds 60 kg, placed outdoors with natural ventilation. Any gozney dome s1 stand has to meet that rule, so a light shelf or a wobbly folding table is not a suitable base.
The manual says the surface must be completely level and stable and capable of easily holding the weight of the oven. It also says the Dome S1 is only suitable for an above ground open-air situation. A gozney dome s1 stand therefore needs a frame and legs that stay steady under that load.
The manual also says the oven must never be placed under or on top of a combustible structure. Treat a wooden stand, a wooden table or any frame with a combustible surface as combustible construction, which means the clearances in the next section apply to it.
Before you place anything, inspect the legs, feet and cross bars of a gozney dome s1 stand, because they carry the 60 kg load. Any wobble or uneven ground will show up as an unstable oven.
A common mistake is checking only the oven’s weight and forgetting the 60 kg floor rating. The rating applies to the whole surface the oven sits on, so check the load limit of the table or stand as well.
Clearances a Gozney Dome S1 Stand Must Leave
Keep 30 cm clear at the back and sides, 100 cm at the front, and 5 cm around the base of the dock for air intake. According to Gozney’s Dome S1 technical manual, these figures are measured from combustible construction, so they apply to the wall, fence or panel beside your gozney dome s1 stand.

| Requirement | Dome S1 figure | What it means for a stand |
|---|---|---|
| Back of the oven | 30 cm from combustible construction | Keep a wall or wooden fence at least this far behind the stand |
| Both sides | 30 cm from combustible construction | Leave room on each side before placing a table or cabinet |
| Front | 100 cm from combustible construction | The largest gap, so plan the stand in open space |
| Base of the dock | 5 cm around for air intake | Do not block the air gap with a panel or shelf |
| Structures, combustible material, other gas cylinder | 1.5 m | Measure from the stand’s position, not from the oven’s mouth |
| Flammable liquid | 7.5 m | Keep fuel, paint thinner and similar liquids well away |
The front clearance matters most in daily use, because you need room to work the peel and turn the pizza. Check the 100 cm front figure against your patio layout before you decide where the gozney dome s1 stand goes.
The front gap is the constraint most owners miss. A stand that fits neatly against a fence or a wall at the back often leaves no room at the front, so measure the full depth you need before you move the stand into place.
Floor Height and Reach at the Oven Mouth
The manual recommends a floor height of about 120 cm, around the level of the bottom of your elbow. That is a recommendation for the surface the oven sits on, so a gozney dome s1 stand that is much lower or higher will change how you reach the mouth.
Working height matters with a peel, because you turn the pizza and lift it out in one motion. A surface that sits too low makes you bend, and one that sits too high makes the mouth harder to see. This is general practical logic rather than a manual rule.
Treat 120 cm as a target for any gozney dome s1 stand, not a fixed size. Whatever height you pick, the surface must stay level and stable, and it must be able to hold the oven’s 60 kg.
Moving the Oven Onto a Gozney Dome S1 Stand
Two people should lift the oven from under its rounded ends, and nobody should use the mouth as a lifting point. Moving the oven onto a stand is the riskiest step for most owners, so follow the manual’s order.

- Remove anything loose and all transit packaging from inside the oven.
- Remove the four blue stone retention wedges and check the stones for a visible gap at the front.
- Plan the route, confirm the oven fits through it, and check the new spot meets the clearances.
- Lift from under the rounded ends with two people, never from the mouth.
- Once the oven is in place, remove the lifting straps on the bottom. They are for single use, and the hand holds below take over.
- Do not move the oven while it is operating or still hot.
After placing the oven, check that the surface is still level. The stones are not fixed inside the oven and can shift backwards during transport, so look for a gap at the front before you light it.

Wind, Enclosure and Where the Oven Cannot Go
The Dome S1 is for outdoor use only and must not be used indoors, in enclosed areas, or under a balcony or deck. The manual also warns against small balconies and says the oven is not designed for a marine craft or a recreational vehicle.
Wind is also a placement issue. The manual says never to operate the oven in high winds or when wind blows into the mouth, so point the mouth away from the wind. If you set a gozney dome s1 stand up in an open area with a wind break, keep the break more than 45 cm from the device.
The manual allows some partial enclosures. A gazebo with an overhead cover and no more than two walls is one example it gives. Walled spaces need openings that meet its stated percentages, so read those in full before you use a covered area.
Eye Bolts, Chain and the Optional Mantle
The box includes eye bolts and a chain, and the manual marks them for use with the stand only, meaning a gozney dome s1 stand. Do not use them for any other purpose.
The manual does not describe how the eye bolts fasten to a stand, so read the stand maker’s assembly instructions before you rely on them.
The Dome S1 Mantle is an optional accessory that bolts onto the oven. The manual describes it as ceramic coated, food grade aluminum alloy for heat and scratch resistance. Optional accessories are not included and must be bought separately. See our Dome S1 accessories guide for more add-ons.
Frequently Asked Questions
Does the Dome S1 manual list stand dimensions?
No. The manual covers clearances, floor loading, floor height, lifting and the box contents, but it does not give the outside size or weight of a stand. Measure the gozney dome s1 stand you plan to use and compare it with the 100 cm front clearance before you order.
Can a Dome S1 sit on a wooden table?
Only if the table is level, stable and able to hold 60 kg. A wooden table counts as combustible construction, so the oven must keep 30 cm at the back and sides and 100 cm at the front. It must never sit under or on top of a combustible structure.
How far should the oven be from the house?
The manual says to keep the oven at least 1.5 m from any structure, combustible material or other gas cylinder. It also sets 7.5 m from any flammable liquid. Check these distances against the full layout of your yard before you set up.
What floor height should I aim for?
About 120 cm, which the manual gives as a recommendation near the bottom of the user’s elbow. Treat it as a target rather than a fixed size, and keep the surface level and stable at whatever height you choose. For general options, see our roundup of pizza oven tables.
Can I use a Dome S1 under a patio cover?
Only if the space meets the manual’s partial enclosure rules, such as an overhead cover with no more than two walls, as in a gazebo. Never use it, or the gozney dome s1 stand it sits on, in an enclosed area or under a balcony or deck, and keep any wind break more than 45 cm from the device.
Before you buy any gozney dome s1 stand, measure the footprint, check its load rating against the oven’s 60 kg surface requirement, and confirm the 100 cm front clearance fits your space. Then confirm the stand’s own dimensions and weight with the seller, since the S1 manual does not list them.
9 min readGear & PantryGozney Dome S1 Cover: What Fits and When to Use ItUpdated Nov 11, 2026
10 min readGear & PantryGozney Dome S1 Stone Replacement: How to Match the Right SideUpdated Nov 11, 2026
9 min readGear & PantryGozney Dome Stand: What to Check Before You Buy a TableUpdated Nov 17, 2026
8 min readGear & PantryGozney Dome Cover: How to Choose and Use One SafelyUpdated Nov 8, 2026
9 min readGear & PantryGozney Dome Peel: How to Pick the Right Blade and TypeUpdated Nov 10, 2026
8 min readGear & PantryGozney Roccbox Stand: Best Table Options for 2026Updated Nov 10, 2026