Gozney Dome S1 Manual: Gas Setup, Leak Test and First Firing
8 min read · by Arjun Mehta · Last updated: November 6, 2026
The Gozney Dome S1 manual is the safety and setup guide for an outdoor gas pizza oven, covering placement, gas connection, leak testing and the first-firing cure. Read the Gozney Dome S1 manual before you light the oven, since it sets the clearances and steps that matter most. Check the model number on your data plate, because regional editions can list different gas figures. If you are on mains gas, see the Gozney Dome S1 natural gas article first.
Gas and fire rules vary by region. Follow the edition that matches your oven and your local code, because this summary does not replace the Gozney Dome S1 manual.
Where to Find the Gozney Dome S1 Manual and Which Version to Use
The Gozney Dome S1 manual comes in regional editions, so the right one depends on your model. The AU/NZ technical manual, DOC-0482-05, runs to 58 pages and is the edition quoted in this guide.
Compare the model number on your oven’s data plate with the Gozney Dome S1 manual you have before you follow any gas figure. A manual for another market can list different rates, hose parts or clearances.
Keep the manual with the oven, and check the Gozney Dome S1 dimensions before you pick a spot. You will need it for the leak test, the first firing and the troubleshooting steps later in this article. The 58-page AU/NZ document covers safety, setup and accessories, firing up the gas, general maintenance and the product warranty.
Safety Rules to Check Before You Light the Dome S1
The Dome S1 is for outdoor use only, in an open, naturally ventilated area, and never inside a home or under a balcony or deck.
The Gozney Dome S1 manual sets fixed distances and rules. The table below lists the ones that matter most before the first firing.
| Hazard | Distance or rule in the manual |
|---|---|
| Structures, combustible material and other gas cylinders | Never operate within 1.5 m |
| Flammable liquids | Never operate within 7.5 m |
| Wind break | Keep it more than 45 cm from the device |
| Strong winds | Do not operate the oven |
According to Gozney’s AU/NZ technical manual, the oven must never run within 1.5 m of any structure, combustible material or other gas cylinder. Strong wind can blow out the flame and push heat out the back, so a wind break is only useful if it stays more than 45 cm away.
Partial Enclosures and Balconies
Under the Gozney Dome S1 manual, a partial enclosure works only when its openings meet the stated rules. A covered gazebo with no more than two walls qualifies. A covered space with more than two walls needs at least 25% of its total wall area completely open, and at least 30% of the remaining wall area open and unrestricted.
On a balcony, at least 20% of the side, back and front wall areas must stay open and unrestricted. The manual also rules out enclosed areas and small balconies, so a setup that fails these rules is outside the manual’s scope.
Dome S1 Gas Setup: Connecting the Cylinder, Regulator and Hose
Set the gas cylinder upright outdoors, connect only the supplied hose and regulator, and run a soapy-water leak test before the first firing.

The gas side of the Gozney Dome S1 manual has the most rules. Treat each step as a safety check, not a formality.
- Keep the cylinder upright outdoors, and never place it under the oven.
- Use a 9 kg cylinder as the minimum the manual recommends.
- Never fill the cylinder beyond 80 percent full.
- Use only the hose and regulator supplied with the oven. The regulator must comply with AS 4627 or an equivalent standard.
- Fit one AAA battery in the ignition module behind the front hatch, negative end first.
The manual also says to check the hose for cuts, cracks and excessive abrasion before each use, and to replace it with a Gozney approved hose assembly if it is damaged. Attach the quick-connect hose by pulling back the collar, placing the hose on the gas inlet, and releasing the collar so it returns freely. Then fit the regulator to the cylinder with the threads aligned, taking care they do not cross, and tighten until the fit is firm.
Leak Test Steps
Run the leak test before the first use, after each cylinder refill, and any time the hose or regulator has been disconnected. The steps below follow the Gozney Dome S1 manual.
- Make sure the cylinder valve is off.
- Brush soapy water over the highlighted connections and along any cracks in the hose.
- Look for bubbles, which show a leak.
- If the leak is at the hose to oven connection, tighten the fitting with a spanner and test again.
- If a leak persists at the oven connection, turn off the gas and do not operate the oven. If the leak is at the valve, swap in a different cylinder and test again.
Never check for leaks with a naked flame, and never light the burner while you are leak checking.
Lighting the Dome S1 and the 30-Minute First Cure
Remove the door and stone retention wedges, press the control knob in, turn it 90 degrees until it clicks, and run the first firing on medium to low for about 30 minutes.

The first firing is the cure, and the manual asks you to take it slowly. Once the 30 minutes are up, you can move to high. For the original model, the Gozney Dome manual summary covers the same topics.
- Confirm the door and the stone retention wedges are removed, since the manual says not to use the door with the gas burner.
- Press the control knob in and turn it 90 degrees until you hear a click and the burner lights.
- Check that the flame is yellow and rolls along the top of the oven.
- Hold the flame on medium to low for about 30 minutes to cure the oven.
- Move to high only after the cure.
After a cure, the Gozney Dome S1 manual says you can bring the oven up from ignition to cooking temperature. If the oven has been dormant for an extended period, cure it again as if it were a first firing.
Troubleshooting a Burner That Will Not Light or Runs Badly
A small flame usually points to a near-empty or undersized cylinder, cold weather below 0°C, or a blocked burner.
| Problem | Possible reasons | What the manual suggests |
|---|---|---|
| Small flame | Cylinder nearly empty or too small; ambient temperature below 0°C; blocked burner | Replace an empty cylinder, use at least 9 kg, clean the burner |
| Failure to ignite | Flat igniter battery; blocked burner; empty cylinder | Hold the knob in for up to 30 seconds on a new cylinder or first firing; replace the battery |
| Noisy flame | Incorrect ignition; blocked burner | Turn to low, then high; if the noise continues, turn off for 5 minutes and retry |
The Gozney Dome S1 manual says a new cylinder or first firing can take up to 30 seconds for gas to reach the burner, so keep the knob in until the pilot lights. If the problem persists, contact Gozney for support, or read our guide on a Gozney Dome that won’t light.
If the flame goes out during use, turn off the control knob and the cylinder valve, and wait 5 minutes before you try again.
Frequently Asked Questions
Can I use the Dome S1 indoors?
No. The Gozney Dome S1 manual says the Dome S1 is only for outdoor, above-ground, naturally ventilated areas. It must not be used indoors, in an enclosed area, under an apartment, balcony or deck, or on a small balcony.
How often should I run a leak test?
The Gozney Dome S1 manual calls for it before the first use, after every cylinder refill, and any time the hose or regulator has been disconnected from the cylinder or the oven. Use soapy water on the connections and watch for bubbles. Never use a flame to check for leaks.
What size gas cylinder does the manual recommend?
The Gozney Dome S1 manual recommends a 9 kg cylinder as a minimum and says not to fill it beyond 80 percent. Keep the cylinder upright outdoors, and do not store a spare in the same area.
How long should the first firing take?
The manual recommends about 30 minutes on a medium to low flame to cure the oven. After that, you can take the oven to high. Cure it again as a first firing if it has sat unused for a long time.
What should I do if the flame goes out?
Turn off the control knob and the cylinder valve, then wait 5 minutes before you try to relight the appliance. Keep the oven under watch while it runs, because some foods produce flammable fats and juices.
Can I put water on a grease fire?
No. The manual says not to use water on an oil or grease fire. Turn off the burner and the cylinder valve, remove the food, and keep away until the fire is out.
Use the Gozney Dome S1 manual as your checklist before every cook, not only the first one. The clearances, leak test and cylinder rules matter most, so confirm that your edition matches your model before you light the oven. When the cooking is done, follow our Gozney Dome cleaning steps.
10 min readBy Use & ModelGozney Dome Manual: Setup, Gas Connection and First FiringUpdated Nov 10, 2026
8 min readBy Use & ModelGozney Roccbox Instructions: Safe Setup, Gas Connection and First FiringUpdated Nov 10, 2026
9 min readBy Use & ModelGozney Dome S1 Dimensions: Outside Size, Clearance and Gas SetupUpdated Nov 7, 2026
7 min readBy Use & ModelGozney Dome S1 Natural Gas: What the Manual Says and What It Does NotUpdated Nov 7, 2026
10 min readBy Use & ModelHow to Use Ooni Koda 12 Safely: From Setup to First FiringUpdated Nov 10, 2026
8 min readBy Use & ModelGozney Dome Natural Gas: Can You Convert It, and What Setup RequiresUpdated Nov 5, 2026