Ooni Koda 16 Accessories: Peels, Thermometer and Stone
9 min read · by Arjun Mehta · Last updated: November 8, 2026
The best ooni koda 16 accessories to start with are a pizza peel, an infrared thermometer and a turning peel. The Koda 16 is a 16-inch gas oven that Ooni rates at 500°C, which it describes as the heat you need in 15 minutes. Ooni’s own pages confirm the fuel, heat and stone details, but they do not confirm which accessories fit this model, so this guide marks that gap clearly.
Ooni Digital Infrared Thermometer Gun
- 0.2 kg
- Prime
Pros & ConsViewHide
Reasons to buy
- Reads surface heat up to 999 F in about 300 milliseconds
- 87% of ratings are 5-star
- Includes 2 AAA batteries
Reasons to avoid
- Reads the surface only, not the air inside the oven
- Battery powered
What the Ooni Koda 16 Needs Before Accessories
The Koda 16 runs on propane or natural gas and reaches 500°C, so every accessory should suit that heat and fuel setup. Ooni’s Koda 16 page describes an extra large 16-inch cooking area and a large cordierite stone baking board. Check those numbers against any of the Ooni Koda 16 accessories you plan to buy.
The table below lists the figures Ooni gives on its Koda 16 product page. Dimensions and weight were not listed there, so look for them in the owner manual or our Ooni Koda 16 dimensions guide before you buy a cover or a table.
| Spec | What Ooni lists |
|---|---|
| Fuel | Propane or natural gas |
| Maximum temperature | 500°C |
| Heat-up time | 15 minutes |
| Cooking area | Extra large 16-inch |
| Baking surface | Large cordierite stone baking board |
Ooni Koda 16 Accessories: Pizza Peels
A pizza peel is one of the Ooni Koda 16 accessories you will use on every bake, because Ooni describes it as essential for getting your pizza in and out of the oven. Pick a peel that is wide enough for your dough and has a handle long enough to keep your hand away from the heat.

Ooni also names an Ooni Pizza Turning Peel. Ooni says you can use it to turn a pizza while it is still in the oven, which helps you get an even colour without lifting the pizza out. Among Ooni Koda 16 accessories, it is a useful second peel once you are comfortable with the launch.
Peels are sold in aluminium and wood. Aluminium is thin and slides under dough easily, while wood is heavier and can hold flour better. Neither type is confirmed as a better fit for the Koda 16 on the pages read, so choose these Ooni Koda 16 accessories by size and how you handle them.
Infrared Thermometer and Stone Temperature
Ooni advises that the baking stone reaches at least 750°F (400°C) before you cook, and that it should return to 715°F to 850°F (380°C to 450°C) before each pizza is launched. An infrared thermometer is the simplest of the Ooni Koda 16 accessories for reading the stone without guessing. For the full heat-up picture, see how hot the Koda 16 gets in our Ooni Koda 16 temperature guide.

Use the thermometer in this order, with the same stone checks on every bake.
- Preheat the oven until the stone reads at least 750°F (400°C).
- After each pizza, check the stone again and wait until it is back in the 715°F to 850°F (380°C to 450°C) range.
- Launch the pizza only when the stone is in that range.
The 750°F and 715°F to 850°F figures come from Ooni’s Koda 12 getting-started page, which gives the same stone guidance for its oven. Confirm the reading on your own Koda 16 with the owner manual.
Cordierite Stone and Baking Surface
The Koda 16 listing describes a large cordierite stone baking board as the cooking surface, and the manual’s parts list shows a stone baking board packed with the oven. You may not need a separate stone, so check your box against that list before you add one to your Ooni Koda 16 accessories list.
The manual gives short stone rules. Do not use the stone over an open flame, avoid sudden temperature changes, and never place frozen food on a hot stone. The stone is fragile and can break if it is bumped or dropped, and it stays hot long after cooking. Never cool a hot stone with water. After water cleaning, dry the stone before use, for example in a conventional oven at 60°C (140°F) for 2 hours. Our how to clean the Ooni Koda 16 guide covers general upkeep.
Fuel, Tanks and Covers
Before you buy any ooni koda 16 accessories, settle the fuel setup, since the Koda 16 runs on propane or natural gas. Ooni says suitable propane tanks can be sourced locally, so you do not need to buy a tank from Ooni to start.
- Propane: Ooni says suitable tanks can be sourced locally. Check the tank and regulator against the owner manual.
- Natural gas: the Koda 16 page lists this as an option. The connection parts are not described on the pages read, so confirm them before ordering.
- Covers: Ooni lists oven covers among its Koda accessories. Match the cover to the oven size shown in the owner manual.
Gas safety is the same whichever fuel you use. Keep the tank outdoors and follow the leak-check steps in the manual before the first use.
Gas Hose, Regulator and Leak Check
The North American Koda 16 manual (Ooni Koda 16 natural gas manual) treats the gas hose as a safety part. It asks you to inspect the hose before every use and replace it if you see abrasion, wear, cuts or a leak. Any replacement should be the hose assembly the manufacturer specifies, so check a third-party hose against the manual before you buy it.
The manual also sets the gas side. It names a 4 iwc natural gas supply, a pressure regulator set for a 4 iwc outlet, and a quick connector that attaches to a 3/8-inch NPT male thread on the supply outlet. Use the regulator supplied with the oven.
Leak testing uses a soapy solution of one part liquid detergent to one part water. Apply it to every fitting with a spray bottle, brush or rag. Bubbles point to a leak. Turn the supply off, tighten the fitting by hand, and test again. If the gas keeps leaking, the manual says not to use the oven until the fault is repaired.
- Keep the hose away from hot surfaces, and make sure it never touches the oven body.
- Tighten the regulator nut clockwise by hand until it stops. The manual warns that a wrench can damage the quick coupling nut.
- Test every connection before lighting, with the burner valve off and the supply valve open.
- Fit dust caps to the hose and quick connector whenever the supply is not in use.
Accessories to Check Before You Buy
Confirm fit for each of the ooni koda 16 accessories before buying, because the pages read did not confirm which items are sized for the Koda 16. Ooni’s Koda 16 accessories page could not be read during this check, so use the listing and manual as the final source.
- Find the Koda 16 named in the product listing, not only a general Ooni pizza oven note.
- Compare the peel width with the 16-inch cooking area before you buy.
- Check the current price on the Ooni site. The Koda 16 page showed a regular price of $649.00 and a sale price of $499.00 as of 2026-11-07.
Koda 16 Burner Figures From the Manual
| Spec | Figure in the North American manual |
|---|---|
| Burner rating | 29,000 BTU/h on one main burner |
| Orifice size | 2.15 mm |
| Gas pressure | 1.00 kPa (4 iwc natural gas) |
| Clearance to combustible construction | 24 inches at the sides, 36 inches at the back |
| Stone | Stone baking board packed with the oven |
Troubleshooting Checks Before You Call Support
The manual’s troubleshooting table points to a short list of causes. Start with these checks before you contact Ooni customer service at [email protected].
| Problem | Likely cause in the manual | First step |
|---|---|---|
| Burner will not light | Coupling nut not fully connected, blocked burner tube, burner not seated on the valve | Tighten the coupling nut by hand only, to a solid stop. Clear the burner tube and reseat the burner. |
| Sudden drop in gas flow or low flame | Gas supply low or regulator not fully connected | Turn the knob off, wait 30 seconds and relight. If the flame stays low, shut the supply, reconnect the regulator and leak test. |
| Flare-up | Grease build-up, fatty meat, high heat or flour left on the cooking surface | Clean the oven, trim fat from meat, lower the heat and brush away loose flour. |
| Flashback | Blocked burner or tubes, or a pressure drop during ignition | Turn the knob off, clean the burner and tubes, then relight once the tank valve is fully open. |
Spiders and insects can nest inside the burner and disrupt gas flow, so the manual asks you to inspect the burner at least once a year. A clogged tube can lead to a fire beneath the oven, so do not skip that check.
Frequently Asked Questions
Does the Ooni Koda 16 run on natural gas?
Ooni’s Koda 16 page says the oven runs on propane or natural gas. Check the owner manual for the connection parts that match your setup before you order, and read our Ooni Koda 16 natural gas guide for the fuel side.
How hot does the Koda 16 get?
Ooni lists a maximum of 500°C, which it describes as the heat you need in 15 minutes. Stone readings are a better guide to when to launch a pizza.
Do I need an infrared thermometer?
Ooni advises a stone reading of at least 750°F (400°C) before cooking. A thermometer lets you confirm that instead of guessing, and it helps between pizzas.
What is the Ooni Pizza Turning Peel for?
Ooni says the turning peel lets you turn a pizza while it is still in the oven. It is an optional second peel rather than a replacement for the launch peel.
Are Ooni accessories interchangeable across models?
The pages read did not confirm model fit for each of the Ooni Koda 16 accessories. Check the product listing or the owner manual for the Koda 16 before buying, and see our Ooni Koda 16 guide for the oven itself.
Is a stone baking board included with the Koda 16?
The manual’s parts list shows a stone baking board packed with the oven. Check your box against that list before you buy a spare stone.
Start your ooni koda 16 accessories list with a peel and a thermometer, since those two tools match what Ooni documents for this oven. Add a turning peel or a cover only after the Koda 16 fit is confirmed on the product listing or in the owner manual.
7 min readBy Use & ModelOoni Koda 12 Accessories: Peels, Thermometers and CoversUpdated Nov 10, 2026
8 min readBy Use & ModelOoni Koda 16 Stone Cracked: What to Do NextUpdated Nov 10, 2026
8 min readBy Use & ModelOoni Koda 2 Max Temperature: Max Heat, Preheat Time and Stone ChecksUpdated Nov 7, 2026
7 min readBy Use & ModelOoni Karu 16 Accessories: Safe, Simple Fit and Fuel GuideUpdated Nov 10, 2026
8 min readBy Use & ModelOoni Koda 16 Won’t Light? Fix It Step by StepUpdated Nov 10, 2026
8 min readBy Use & ModelOoni Koda 16 Recipes: 6 Easy Official Ideas to TryUpdated Nov 6, 2026