Ooni Koda 2 Max Temperature: Max Heat, Preheat Time and Stone Checks
8 min read · by Arjun Mehta · Last updated: November 7, 2026
The Ooni Koda 2 Max temperature tops out at 950°F (500°C), and Ooni says the oven is ready to cook in about 30 minutes. The Koda 2 Max is a 24-inch gas oven with two independent burners, so you can hold two different heat levels at once. This guide covers the preheat, the stone check and what can stop the oven reaching its top heat.
Use these Ooni Koda 2 Max temperature figures as Ooni publishes them, and check them against the manual for your own gas version. Gas ovens are outdoor appliances, so keep the placement and clearance rules in mind before you light it.
What is the Ooni Koda 2 Max temperature limit?
Ooni states a top temperature of 950°F (500°C) for the Koda 2 Max, and it lists Neapolitan-style pizza in as little as 60 seconds at that heat.

Ooni’s Koda 2 Max product page gives the 950°F / 500°C top temperature, the ceiling for the Ooni Koda 2 Max temperature, alongside a 24-inch cooking area, thick pizza stones and a removable glass visor. The same page describes the oven as gas-powered, with two independently controlled burners and a tapered flame that spreads heat evenly across the stones.
That top figure is a design ceiling, not a setting you must reach for every cook. Most of the time you will run the Ooni Koda 2 Max temperature lower for roasting or low and slow cooking on one side while the other side stays hot for pizza. If you cook with pellets instead of gas, the Fyra 12 heat control depends more on hopper level and door habits than on burner settings.
Gas supply matters too. Ooni says natural gas can be used only with the Koda 2 Max natural gas version sold in the US, so read Ooni Koda 2 Max natural gas before you connect a different fuel.
How long does the Koda 2 Max take to heat up?
Ooni says the Koda 2 Max is ready to cook in about 30 minutes, and the manual tells you to preheat both burners at full power for at least 30 minutes.

The manual’s cooking section says to turn both burners on at full power to preheat the oven and the two pizza stones for at least 30 minutes. That time is for a cold start on a normal day. Ooni also notes that preheat time and the Ooni Koda 2 Max temperature can be affected by location and weather conditions, so adjust the expected wait when it is cold, wet or windy.
| Topic | What Ooni publishes | Where it comes from |
|---|---|---|
| Top temperature | 950°F / 500°C | Koda 2 Max product page |
| Ready to cook | About 30 minutes | Koda 2 Max product page |
| Manual preheat | At least 30 minutes, both burners at full power | Koda 2 Max manual, cooking section |
| First-use seasoning | Run at top temperature for 30 minutes, then cool and wipe the inside with dry paper towels | Koda 2 Max manual, lighting section |
| Stone self-clean | Full power for 45 minutes with no food inside | Koda 2 Max manual, cleaning section |
If you want a comparison with a smaller gas oven, how long the Ooni Koda 2 takes to heat up is a different model with its own timing, so do not swap the numbers between them.
How do you measure the real Ooni Koda 2 Max temperature at the stone?
Measure the stone with an infrared thermometer as well as the oven’s air reading, because Ooni says the pizza stone heats up more slowly than the air inside the oven.
The manual strongly recommends an Ooni Digital Infrared Thermometer to measure the pizza stone temperature. It also says to use that thermometer together with the Digital Temperature Hub so the stone and air temperatures sit within a close range. For pizza you want a balance of both, so a high air reading alone does not mean the stone is ready.
- Light both burners and preheat at full power for at least 30 minutes.
- Check the air temperature on the Digital Temperature Hub in the Ooni app.
- Aim the infrared thermometer at the surface of each stone, not at the flame.
- Wait until the stone reading is close to the air reading, then start cooking.
The Digital Temperature Hub sends the oven’s ambient air temperature and the readings from the two meat probes to your phone over Bluetooth, according to Ooni. The hub reports the air temperature, so the infrared reading still matters for the stone.
How do the two burners change Ooni Koda 2 Max temperature control?
The Koda 2 Max has two independent burners, so you can cook on one side only, on both sides at the same temperature, or on both sides at different temperatures.
Ooni lists variable heat control for high, medium and precision low-power cooking. That gives you room to run a pizza side at full heat while the other side stays cooler for a skillet side or a roast, which is the main way this oven changes Ooni Koda 2 Max temperature planning compared with a single-burner model.
- Pizza and other dry, bread-based dishes cook directly on the pizza stone.
- Meat, vegetables and other dishes need Ooni Cast Iron, Ooni Pans or other Ooni-approved cookware, according to the manual.
- Two food probes are included, so you can cook meat to temperature without opening the oven.
- Never reach into the oven to clear fallen food; leave it to burn out and remove it once the oven is cool.
The manual notes that the oven can burn on one side while the other is off, so decide your zones before you light the second burner. For the footprint of the oven, see the Ooni Koda 2 Max dimensions.
What can stop the Ooni Koda 2 Max temperature reaching its top?
The manual’s troubleshooting table lists gas flow, cylinder and regulator pressure, setup and positioning, weather, a backlighting burner, a removed visor and a tripped regulator as reasons the oven is not hot enough.
- Make sure the cylinder has fuel and sits upright, because an empty or nearly empty can affect performance, and check the hose for kinks.
- Shelter the oven from wind, or at least position it so the mouth faces away from the wind.
- If the oven has been exposed to moisture or cold, it may take longer to preheat. Ooni suggests storing it under a waterproof cover and bringing the pizza stones indoors during long periods without use.
- Reinstall the glass visor if you removed it, because preheat time and maximum temperature can be affected when cooking without it.
- If the regulator safety has tripped, turn off the gas, disconnect the regulator from the cylinder for 5 minutes to reset it, then relight.
If the Ooni Koda 2 Max temperature still looks low after these checks, the manual points you to Ooni support. The Pro model has its own limits, so read Ooni Koda 2 Pro temperature if you own that oven instead.
Setup and safety that affect Ooni Koda 2 Max temperature
Placement changes how the oven heats, so set it up on a sturdy surface with the mouth facing away from the wind before you chase a higher temperature.
- Use the oven outdoors only, never inside a building, garage or other enclosed area.
- Keep it at least 40 inches (1 m) from any structure, combustible material or other gas cylinder, and 25 ft (7.5 m) from any flammable liquid.
- Use a sturdy metal or wood surface, not a plastic or glass table. Ooni recommends the stone sit at about 1.1 m from the ground.
- Season the oven before the first cook by running it at top temperature for 30 minutes, then let it cool completely and wipe the inside with dry paper towels.
- Wear gloves when putting your hand inside the oven, and never leave it unattended while lit.
The Ooni Koda 2 Max manual also gives a minimum operating temperature of 0°F (-17.8°C) on the rating plate, which matters if you cook in winter. For a summary of the other rules, see the Ooni Koda 2 Max manual guide.
Frequently Asked Questions
What is the Ooni Koda 2 Max temperature at its maximum?
Ooni lists a top temperature of 950°F (500°C) for the Koda 2 Max. It also says the oven is ready to cook in about 30 minutes, though weather and location can change the wait.
How long should I preheat for the right Ooni Koda 2 Max temperature?
The manual says to preheat both burners at full power for at least 30 minutes. In cold or damp conditions it may take longer, so confirm with a stone reading from an infrared thermometer.
Can I cook meat at the Ooni Koda 2 Max temperature directly on the stone?
No. The manual says to cook only pizza and other dry, bread-based dishes directly on the pizza stone. Use Ooni Cast Iron, Ooni Pans or other Ooni-approved cookware for meat and vegetables.
Can I use the Koda 2 Max indoors?
No. Ooni says the oven is built for outdoor use and is not suitable for indoor use. Keep it at least 40 inches (1 m) from any structure.
How can I see the Ooni Koda 2 Max temperature on a display?
It works with the Ooni Connect Digital Temperature Hub, which sends air temperature and probe readings to the Ooni app. Ooni recommends pairing it with an infrared thermometer to check the stone.
Treat 950°F as the ceiling, not the target. Preheat for at least 30 minutes, check the stones with an infrared thermometer, and use the two burners to match the Ooni Koda 2 Max temperature to the dish. Keep the manual with the oven for the gas, placement and troubleshooting steps.
9 min readBy Use & ModelOoni Koda 2 Pro Temperature: Max Heat and How to Check ItUpdated Nov 7, 2026
9 min readBy Use & ModelOoni Karu 2 Temperature: Max Heat, Stone Targets and Fuel LimitsUpdated Nov 8, 2026
7 min readBy Use & ModelOoni Fyra 12 Temperature: Max Heat, Heat-Up Time and ControlUpdated Nov 7, 2026
8 min readBy Use & ModelOoni Karu 16 Temperature: Max Heat, Cooking Targets and Fuel LevelsUpdated Nov 10, 2026
9 min readBy Use & ModelOoni Volt 2 Stone Cracked? What to Check and What to DoUpdated Nov 10, 2026
10 min readBy Use & ModelOoni Koda 2 Max Manual: What the Official Guide SaysUpdated Nov 6, 2026