Ooni Koda 16 Won’t Light? Fix It Step by Step
8 min read · by Arjun Mehta · Last updated: November 10, 2026
If your Ooni Koda 16 won’t light, check the gas connections first, then turn the control knob slowly, as the official Essentials Guide advises. The guide’s fixes focus on gas flow, the regulator and leaks rather than the spark itself.
The steps below follow the troubleshooting section of Ooni’s guide and keep its timings, so you can check each one against your own copy of the manual.
Propane is a fuel, and the Koda 16 is designed to run at up to 950°F / 500°C. Follow the manufacturer’s safety steps, and stop at once if you smell gas.
Why the Ooni Koda 16 Won’t Light
Ooni’s guide says to push in and turn the gas control very slowly from off, so gas flows into the oven before the spark fires near 9 o’clock. If you own a multi-fuel Karu 16 instead, lighting the Karu 16 with different fuels covers wood, charcoal and gas.

According to the Ooni Koda 16 Essentials Guide, you should hear the gas flowing before the dial reaches 9 o’clock. Lighting can take a few attempts, depending on how long it has been since the last firing, the ambient temperature, the weather and your gas setup.
If your Ooni Koda 16 won’t light on the first try, take care during this step. The guide warns not to look directly into the oven while lighting, because flames may escape from the mouth during the first firing. It also says not to leave the oven unattended while it is lit.
Ooni Koda 16 Won’t Light? Check the Gas Connections
Before every cook, the guide says to check every gas connection for leaks, using soapy water or a leak detector spray. Work through these checks in order.
- Make sure the propane tank is full and stands upright.
- Clear any debris from the regulator and tank connections, then reattach the regulator.
- Check that the gas hose is not tangled, comes away from the oven and does not pass under it.
- Apply soapy water or leak detector spray to the connections between the tank and the oven, and on the hose. Bubbles mean a leak.
- If you see bubbles, switch off the gas and check the fittings. If bubbles keep appearing, switch off the gas and service the regulator.
The guide is firm on one point: never cook with a product that has failed the leak test. It asks you to contact support.ooni.com for further advice in that case.
Ooni Koda 16 Won’t Light: Reset the Regulator and Open the Tank Slowly
If the regulator’s safety feature has tripped, the guide suggests disconnecting it from the tank for 5 minutes to reset it before you try again.
For US twist-open gas bottles, open the gas flow very slowly. The guide says a sudden surge of gas through the regulator can trip the built-in safety feature.
When an Ooni Koda 16 won’t light after a reset, remember it is not a repair. If bubbles keep appearing after you check the connections, the guide says to service the regulator rather than keep trying to light the oven. Owners of the smaller oven can follow our Koda 12 lighting troubleshooting page, though some steps may differ between the two models.
Relight Safely After a Failed Attempt
If the flame goes out, wait 5 minutes, then push the control knob in and turn it from 12 to 9 o’clock over at least 3 seconds.

- Wait 5 minutes before you relight, and keep the gas switched off during that time.
- Push the knob in and turn it slowly counter-clockwise from 12 to 9 o’clock. The guide says this should take at least 3 seconds, so gas can flow into the oven.
- Keep pushing the knob in for 20 seconds after ignition, then release it.
- If you are using the oven in wind, make sure the wind enters the back of the oven.
If your Ooni Koda 16 won’t light and stay lit, the guide also points to the Flame Safety Device. It cuts off the gas when the thermocouple does not read a high enough temperature. Wipe the thermocouple with a dry paper towel, or blow it with compressed air if you cannot reach it. Our guide on how to clean the Ooni Koda 16 covers the rest of the oven.
Roaring Flames and a Slow Preheat
A louder-than-normal roar from the burner means it did not ignite correctly, so the guide says to switch off for 5 minutes and relight.
The guide says a Koda 16 should run quietly when lit. Incorrect lighting can result in overheating and damage, so follow the lighting steps carefully rather than repeating them quickly.
If the oven seems slow to heat, the guide says it is designed to reach its optimum temperature in about 20 minutes. Add 10 to 15 minutes when the ambient temperature is low. Then check the following.
- The propane tank is full.
- You are using the correct regulator.
- The hose and the connections between the regulator and tank have no leaks.
The guide suggests the Ooni Infrared Thermometer to check the stone temperature before you cook. It also says the Koda 16 should not be left running at top temperatures for extended periods without cooking, so turn it off if you take a break. If the oven runs too hot instead, reduce the output with the gas control knob, and rest a cast iron dish on the stone for about 30 seconds to absorb some heat.
Once the oven lights and heats properly, two more tips from the guide help with the bake. For a Neapolitan-style or other thin pizza, aim for 750°F (400°C) at the centre of the stone, measured with the Infrared Thermometer before you launch. If a pizza is burning, dial the flames down right after launch, make the first turn after 20 to 30 seconds, then return the flames to maximum. For more on how hot it runs, see how hot the Ooni Koda 16 gets.
If You Smell Gas, Act First
If you smell gas, the guide says to close the valve on the propane tank, put out any open flame and call your local fire department if the smell persists.
- Close the valve on the propane tank.
- Put out any open flame.
- If the smell persists, keep a safe distance and contact your local fire department.
The guide also says not to apply water to any part of the oven to extinguish or cool it, because this can cause damage and personal injury.
What This Guide Does Not Cover
This article follows the written troubleshooting steps in the Koda 16 Essentials Guide, and it does not describe the lighting diagram on page 15.
The lighting steps on page 15 appear as an image in the PDF, and their text could not be read for this article. Check that page in your own copy of the guide. Natural gas owners should read the Ooni Koda 16 natural gas guide because this article covers propane.
The Koda 16 is a different model from the Koda 12 and Koda 2, so their steps may differ. For country-specific tank connection instructions, the guide points to the manual, shown on page 12.
Frequently Asked Questions
My Ooni Koda 16 won’t light even with a full tank: why?
A full tank is not enough on its own. The guide says to check that the tank is upright, the connections are clear and the hose has no leaks, then to turn the control knob slowly.
How long should I wait before trying to light it again?
Wait 5 minutes after the flame goes out, and keep the gas switched off during that time. The guide gives the same 5-minute wait after a roaring sound.
Can I light the Koda 16 with a match?
The guide shows a matchstick holder on page 12 and says to check the lighting instructions to see when a match is used. Those lighting pages are images in the PDF, so follow the manual that came with your oven.
How long should I hold the knob after the oven lights?
Keep pushing the control knob in for 20 seconds after ignition, then release it. The guide gives this timing in its troubleshooting section.
Can I use water to put out the flame or cool the oven?
No. The guide says not to apply water to any part of the oven to extinguish or cool it, because this can cause damage and personal injury.
Can I use the Koda 16 indoors?
No. The guide says the Koda 16 is designed for outdoor use only and should not be used in high winds.
If your Ooni Koda 16 won’t light after the connection checks and the relight steps, stop trying and contact Ooni support, as the guide suggests. Do not cook with a product that has failed a leak test. For a step-by-step on normal operation, see the Ooni Koda 16 instructions. Other faults are covered in our overview of common Ooni Koda 16 problems.
8 min readBy Use & ModelOoni Koda 12 Won’t Light? Step-by-Step FixesUpdated Nov 10, 2026
9 min readBy Use & ModelGozney Dome Won’t Light? Check the Battery, Gas Flow and BurnerUpdated Nov 10, 2026
7 min readBy Use & ModelOoni Karu 16 Charcoal: How to Light, Heat and Refuel ItUpdated Nov 6, 2026
8 min readBy Use & ModelHow to Light Ooni Karu 16 With Wood, Charcoal or GasUpdated Nov 7, 2026
8 min readBy Use & ModelOoni Koda 16 Stone Cracked: What to Do NextUpdated Nov 10, 2026
8 min readBy Use & ModelOoni Koda 16 Recipes: 6 Easy Official Ideas to TryUpdated Nov 6, 2026