Ooni Koda 2 Max Manual: What the Official Guide Says
10 min read · by Arjun Mehta · Last updated: November 6, 2026
The Ooni Koda 2 Max manual is the official guide for setting up, lighting and caring for this outdoor gas pizza oven. The US edition is titled 28mbar US, so its gas rating is printed right in the document name. Match that rating to the plate on your oven before you connect anything.
Read the safety section before you touch the gas. Clearance, leak testing and the lighting order matter more than the cooking steps.
Gas appliances can cause fire, explosion or burn injuries. Follow the manual and your local codes, and contact Ooni support whenever a step is unclear.
Where to Find the Official Ooni Koda 2 Max Manual
Ooni’s US manual for the Koda 2 Max is a 13-page PDF with English and Spanish sections. The file is labeled 28mbar US, so you can confirm it matches your oven before you follow any step.
The Ooni Koda 2 Max manual is the document to keep beside you during setup. Ooni’s Koda 2 Max getting-started page lists the oven at 800 x 740 x 428 mm (31.7 x 34 x 14.4 in), with two pizza stones of about 672 x 525 mm each. It says the oven cooks two 12-inch pizzas or three 10-inch pizzas at once.
The getting-started page says assembly takes less than 30 minutes. The manual adds a warning: the oven is very heavy, so two people must lift, assemble and position it. Plan for a helper before you open the box, and see the Ooni Koda 2 Max dimensions guide for the footprint.
For cooking guidance, the manual sends you to the Ooni app, and our Ooni Koda 2 Max temperature guide covers heat in more depth. The printed guide focuses on safety, setup, lighting, care and troubleshooting.
Safety Distances and Outdoor Placement
Keep the Koda 2 Max at least 40 inches (1 m) from any structure, combustible material or gas cylinder, and use it outdoors only. The Ooni Koda 2 Max manual sets these limits as firm rules, not suggestions.

- Keep the oven 40 inches (1 m) from any structure, combustible material or gas cylinder.
- Never operate it within 25 feet (7.5 m) of a flammable liquid.
- Use it outdoors only. The manual says never to use it in a garage, enclosed area, boat or recreational vehicle, and never as a heater.
- Position the mouth of the oven so it faces away from the wind.
- Keep the gas cylinder at least 25 inches from the oven, and never store a spare cylinder under or near it.
- Do not use it under overhead construction. The minimum ambient operating temperature is 0°F (-17.8°C).
Connecting the Gas Cylinder and Checking for Leaks
Turn both control dials to OFF before you connect the cylinder, then test every fitting with soapy water, because bubbles mean a leak. Only connect the gas listed on the rating plate. If you are weighing a natural gas setup, read Ooni Koda 2 Max natural gas before you buy fittings.
- Turn both control dials to OFF, and make sure the cylinder valve is closed.
- Inspect the valve connections, regulator and hose for debris or damage, and check the hose before every use.
- Connect the regulator by turning the hand nut counterclockwise, then open the cylinder valve slowly.
- Mix dish soap with water, brush the solution on the connections and regulator, and watch for bubbles.
- If a fitting bubbles, tighten it and check again. If the leak continues or the hose is cracked, do not operate the oven and contact Ooni support.
The Ooni Koda 2 Max manual sets clear cylinder limits. Use only a cylinder under 20 lb (9.1 kg), no more than 22.8 inches (580 mm) across or tall. Never fill it beyond 80 percent full. Keep the regulator where it will not get hotter than 130°F (54.5°C), and keep the hose away from heated surfaces and off the oven body.
The Ooni Koda 2 Max manual lists the US replacement regulator as Model A300USL. The manual says to use the regulator and hose supplied with the oven, and to contact Ooni support if you have another cylinder.
Lighting the Burners Step by Step
Push and hold a control dial in, turn it counterclockwise until the burner sparks, then hold for 5 seconds after it lights. The left dial controls the left burner and the right dial controls the right one. Stand to the side and never look straight into the oven while lighting.

- Push and hold the dial in while slowly turning it counterclockwise to spark the burner.
- Keep holding for 5 seconds after the gas lights, then release the dial.
- If the burner does not light, turn the dial to OFF, wait 5 minutes and try again.
- After a second failed attempt, turn the dial to OFF, wait 5 minutes, then use the matchstick holder on the base of the oven.
- To light with a match, push the dial in and turn it to maximum while touching the lit match to the burner through the mouth of the oven.
According to the Ooni Koda 2 Max manual, the oven runs on an AA ignition battery in the rear leg. The full lighting section is in Ooni’s US 28mbar manual, section 4, and you should read it before your first fire.
Seasoning and Preheating the Oven
Season the oven at top temperature for 30 minutes, then preheat both burners on full for at least 30 minutes before the first pizza. Seasoning and preheating are separate steps, and each one needs a cooldown or a full warm-up.
To season, follow the Ooni Koda 2 Max manual and run the oven at top temperature for 30 minutes. Turn it off, let it cool completely, then wipe the inside with dry paper towels. Wear gloves whenever your hand goes inside the oven.
Before cooking, turn both burners to full power and preheat the oven and stones for at least 30 minutes. The Ooni Koda 2 Max manual recommends an Ooni Digital Infrared Thermometer to read the stone, because the stone heats more slowly than the air. The Digital Temperature Hub that comes with the oven tracks air temperature, so you can keep both readings close together.
Wind, cold and moisture can all lengthen preheating, a point the Ooni Koda 2 Max manual makes in its troubleshooting section. If the oven has been exposed to damp or cold, the manual says it may take longer to heat up, so store it under a waterproof cover and bring the stones indoors during long breaks.
Cleaning, Storage and Warranty Steps
Wipe the interior once it cools, clean the shell with warm soapy water, and never add water or chemicals to the pizza stones. The Ooni Koda 2 Max manual also warns against abrasive cleaners and scouring pads on any part of the oven.
- Interior: after each use, let the oven cool completely, then wipe the inside and burner tubes with dry paper towels.
- Glass visor: wipe with a damp cloth. For stubborn stains, remove the visor using the steps in section 5.1 of the manual.
- Shell: wipe with warm soapy water, dry it straight away, and cover the oven.
- Stones: never wash them. Run the oven at full power for 45 minutes, let it cool, then brush off the ash with an Ooni pizza oven brush.
- Storage: remove the AA ignition battery if the oven will sit unused for more than a month.
The Ooni Koda 2 Max manual notes that the stones are double-sided and symmetrical, so you can turn them over between uses once they are cool. The manual says the warranty is 1 year as standard, extended to 5 years if you register at ooni.com/warranty within 60 days of purchase, subject to the terms and conditions.
Troubleshooting Common Manual Problems
Most ignition and heat problems come from the gas cylinder, the regulator, wind or a dirty flame sensor, and the Ooni Koda 2 Max manual lists a fix for each. Work through the table from the top before you call support, and keep the Ooni Koda 2 Max manual open beside you.
| Problem | Manual fix |
|---|---|
| Oven won’t ignite | Confirm the setup, check the cylinder has fuel and stands upright, check the regulator is attached, and check the ignition battery and cable. Light with a match if needed. |
| Burners light but won’t stay lit | Hold the dial for at least 5 seconds after ignition. If it still fails, turn off the gas, let the oven cool, and clean the Flame Supervision Device thermocouple with a damp cloth. |
| Oven isn’t getting hot enough | Check that the cylinder has fuel and the hose has no kinks, shelter the mouth from wind, and disconnect the regulator for 5 minutes to reset its safety feature. |
| Sooty flame or soot inside | Remove food debris from the stone, use less flour when launching pizza, and check the setup. If the gas venturi is blocked, contact Ooni support. |
If a problem persists after you have checked the Ooni Koda 2 Max manual, contact Ooni customer support at support.ooni.com. Do not try to modify the appliance or use parts that are not Ooni-approved.
Frequently Asked Questions
Is the Koda 2 Max manual the same for every country?
No. The US copy is titled 28mbar US, so its gas rating is printed in the document name. Check the rating plate on your oven and match it to the Ooni Koda 2 Max manual before you follow any setup step. The manual says to connect only the gases listed on that plate.
Can I use the Koda 2 Max indoors?
No. The manual says the oven is for outdoor use only, and it must not be used inside a building, garage or other enclosed area, on a boat or in a recreational vehicle. It is not intended as a heater.
Do I need a special thermometer?
The Ooni Koda 2 Max manual recommends an Ooni Digital Infrared Thermometer to measure the pizza stone. The stone heats more slowly than the air, so the manual also asks you to watch the Digital Temperature Hub to keep both readings in a close range.
How long does the oven take to preheat?
The manual says to run both burners on full power for at least 30 minutes to preheat the oven and the stones. Wind, cold and moisture can lengthen that time, so adjust your expectations to the conditions outside.
What should I do if I smell gas?
Following the Ooni Koda 2 Max manual, close the gas cylinder or regulator valve, turn both control dials to OFF, and put out any open flames. If the odor continues, keep away from the appliance and call your fire department right away.
Can I cook meat in the oven?
The Ooni Koda 2 Max manual says to cook only dry, bread-based dishes directly on the pizza stone. For meat, vegetables or other dishes, use Ooni cast iron, Ooni pans or other Ooni-approved accessories. Never reach in to clear food debris while the oven is hot.
Read the Ooni Koda 2 Max manual before you connect the gas, and keep the clearance and leak checks at the top of your routine. If anything in the manual conflicts with the rating plate on your oven, stop and contact Ooni support before you light the burners.
7 min readBy Use & ModelHow Long Does Ooni Koda 2 Take to Heat Up? Official TimingUpdated Nov 7, 2026
9 min readBy Use & ModelOoni Koda 2 Pro Temperature: Max Heat and How to Check ItUpdated Nov 7, 2026
8 min readBy Use & ModelOoni Koda 2 Max Temperature: Max Heat, Preheat Time and Stone ChecksUpdated Nov 7, 2026
8 min readBy Use & ModelOoni Koda 2 Max Natural Gas: Which Model to Use and How to Connect It SafelyUpdated Nov 6, 2026
8 min readBy Use & ModelOoni Koda 2 Max Dimensions: Size, Weight and Cooking Area GuideUpdated Nov 7, 2026
9 min readBy Use & ModelOoni Koda 2 Pro Manual: Step-by-Step Use GuideUpdated Nov 7, 2026